Enabling real-time display for a Telnet or SSH session
To enable the real-time display for a Telnet or SSH session, enter the following command from the Privileged exec mode of the session.
telnet@device#terminal monitor Syslog trace was turned ON
Notice that the CLI displays a message to indicate the status change for the feature. To disable the feature in the management session, enter the terminal monitor command again. The command toggles the feature on and off.
telnet@device#terminal monitor Syslog trace was turned OFF
The following example shows how the Syslog messages are displayed.
telnet@device#terminal monitor Syslog trace was turned ON SYSLOG: <9>device, Power supply 2, power supply on left connector, failed SYSLOG: <14>device, Interface ethernet 6, state down SYSLOG: <14>device, Interface ethernet 2, state up