stack enable
Enables stack configuration on the device. Enter this command on the intended active controller.
Syntax
Command Default
Stacking is not enabled on the device.
Modes
Global configuration mode
Stack unit configuration mode
Usage Guidelines
Use the no form of the command to remove stacking capability from the device.
When you use the no stack enable command, the unit can still be called to join an active stack. To prevent this, use the stack disable command instead.
You must remove all configuration information from the port before issuing the stack enable command.
For manual configuration, the stack enable command must be issued on each device in the stack.
Examples
The following example enables stack configuration on the device.
device# config terminal device(config)# stack enable Enable stacking. This unit actively participates in stacking
History
Release version | Command history |
---|---|
08.0.00a | This command was introduced. |