Configuring Device IP Address Settings

If you need to update the IP address and DNS server settings of your Unleashed Master AP, follow the steps outlined below.

NOTE
As soon as the IP address has been changed (applied), you will be disconnected from your web interface connection to the Unleashed Master AP. You can log into the web interface again by using the new IP address in your web browser.

To change the IP address settings:

  1. Go to Admin & Services > System > IP Settings.
  2. Review the IP Settings options.
    NOTE
    Gateway mode can only be enabled using the Setup Wizard. If you want to enable Gateway mode, you must factory reset the AP and enable it during the initial configuration. See Gateway Mode.
  3. Select one of the following:
    • Manual: If you select Manual, enter the correct information in the now-active fields (IP Address, Netmask, and Gateway are required).
    • DHCP: If you select DHCP, no further information is required. The Unleashed Master will obtain an IP address automatically.
  4. Click Apply to save your settings. You will lose connection to the Unleashed Master.
  5. To log back into the web interface, use the newly assigned IP address in your web browser or use the UPnP application to rediscover the Unleashed Master AP.
    Figure 161  Configuring device IP address settings