Configuring a standard ACL

To configure a standard ACL, perform the following steps.

  1. Click Configure on the left pane and select IP .
  2. Click Standard ACL .

    The Standard ACL window is displayed as shown in the figure below.

    NOTE
    Web GUI does not have ACL Sequence number support.
    Figure 103  Configuring standard ACLs
  3. Type the ACL number from 1 through 99 in the Standard ACL Number field. If you want to type an ACL name, click Name ACLs . The field label changes to Standard ACL Name . Now you can type an ACL name up to 256 alphanumeric characters in length.
  4. Click Permit or Deny for Action so that the packets that match a policy in the ACL can be permitted (forwarded) or denied (dropped).
  5. Type the host IP address in the IP Address field.
  6. Type the IP subnet mask in the Filter Mask field.
  7. Type the host name in the Host Name field.
  8. Select the Log check box so that the device generates syslog entries and SNMP traps for the packets that are denied by the access policy.
  9. Click Add .

    The message The change has been made is displayed and the ACL is added. To display the configured ACL, click Show ACLs .

    To delete the configured ACL, click Delete . To reset the data entered in the configuration pane, click Reset .

Parent topic: Configuring IP