Configuring an IP Autonomous System-path access list

To configure an Autonomous System-path access list, perform the following steps.

  1. Click Configure on the left pane and select IP .
  2. Click Autonomou System Path Access List .

    The IP Autonomous System Path Access List window is displayed as shown in the figure below.

    Figure 106  Configuring the IP Autonomous System-path access list
  3. Type the ACL name in the Name field.
  4. Type the Autonomous System-path list sequence number in the Sequence (0 - System Set) field. You can configure up to 199 entries in an Autonomous System-path list.

    If you do not specify a sequence number, the software numbers the entries in increments of five, beginning with number 5. The software interprets the entries in an Autonomous System-path list in numerical order, beginning with the lowest sequence number.

  5. Click Deny or Permit for Action .
  6. Type the Autonomous System-path information you want to permit or deny to routes that match any of the match statements within the ACL in the Regular Expression field.
  7. Click Add .

    The message The change has been made is displayed. To display the configured Autonomous System-path list, click Show .

    To modify the Autonomous System-path list, click Modify . You can also delete the Autonomous System-path list by clicking Delete . To reset the data entered in the configuration pane, click Reset .

Parent topic: Configuring IP