Configuring a UDP helper

To configure a helper address on the interface connected to the clients, perform the following steps.

  1. Click Configure on the left pane and select IP .
  2. Click UDP Helper .

    The UDP Helper window is displayed as shown in the figure below.

    Figure 115  Configuring UDP helper
  3. Select a Unit ID from the Select Unit list and click Get Ports to retrieve the list of ports corresponding to the selected Unit ID.
    A message is displayed to indicate that the operation does not change the running configuration.
  4. Select an Ethernet port in the Port list.
  5. Type the server IP address or the subnet directed broadcast address of the IP subnet the server belongs to in the IP Address field.
  6. Click Add .

    The message The change has been made is displayed. To display the configured UDP helper, click Show .

    To modify the configured UDP helper, click Modify . You can also delete the UDP helper by clicking Delete . To reset the data entered in the configuration pane, click Reset .

Parent topic: Configuring IP