Displaying PIM6 SM snooping for a VLAN
You can display PIM6 SM snooping information for all groups by entering the following command at any level of the CLI on a Layer 2 switch.
Device#show ipv6 multicast pimsm-snooping vlan 25 vlan 25, has 2 caches. 1 (0:11 1:3) has 2 pim join ports out of 2 OIF 1/1/2 (age=30), 2/1/3 (age=30), 1/1/2 has 1 src: 15::11(30), 2/1/3 has 1 src: 15::11(30), 2 (0:16 1:3) has 2 pim join ports out of 2 OIF 2/1/3 (age=90), 1/1/2 (age=10), 1/1/2 has 1 src: 15::16(10),
Syntax: show ipv6 multicast pimsm-snooping vlan vlan-id
Enter the ID of the VLAN for the vlan-id parameter.
The following table describes the information displayed by the show ipv6 multicast pimsm-snooping command.
Field |
Description |
---|---|
VLAN ID |
The port-based VLAN to which the following information applies and the number of members in the VLAN. |
PIM6 SM Neighbor list |
The PIM6 SM routers that are attached to the Layer 2 Switch ports. The value following "expires" indicates how many seconds the Layer 2 Switch will wait for a hello message from the neighbor before determining that the neighbor is no longer present and removing the neighbor from the list. |
Multicast Group |
The IP address of the multicast group. NOTE The fid and camindex values are used by Brocade Technical Support for troubleshooting.
|
Forwarding Port |
The ports attached to the group receivers. A port is listed here when it receives a join message for the group, an MLD membership report for the group, or both. |
PIMv2 Group Port |
The ports on which the Layer 2 Switch has received PIM6 SM join messages for the group. |
Source, Port list |
The IP address of each PIM6 SM source and the Layer 2 Switch ports connected to the receivers of the source. |
Refer to the FastIron Command Reference for more information on PIM SM commands.