Copying the flash image to a stack unit from the active controller
You can replace a bad image on a stack unit or an image that does not match the active controller's image by copying the correct flash image from the active controller.
To copy the flash image to a stack unit from the active controller primary or secondary flash, enter the following command at the device prompt.
device# copy flash flash unit-id-pri 2
Syntax: copy flash flash [ primary | secondary | unit-id-pri unit-num |unit-id-sec unit-num ]
- primary - Copy secondary to primary
- secondary - Copy primary to secondary
- unit-id-pri - Copy active primary image to unit ID
- unit-id-sec - Copy active secondary image to unit ID
The unit-id-pri and unit-id-sec keywords are used to copy images to a stack member from the active controller primary and secondary flash, respectively. For unit-num, enter a valid stack unit number from 1 through 8 (1 through 12 for ICX 7450 or ICX 7750 devices).